當前位置: 首頁 - 解決方案

  • 標題: 光伏組件氨氣試驗箱
  • 上架時間: 2016-10-19
  • 浏覽次數 : 112

返回

  • 詳細介紹

主要功能特點
1.滿足IEC62716中關于氨氣檢測的試驗要求,整個試驗箱爲我司首創,填補了國內空白。
2.整個箱體采用無縫焊接密封,杜絕氨氣泄露。
3.高耐腐蝕專用試樣架以及內壁材料,保證了試驗的正確性和穩定性,以及試驗箱的使用壽命。 
4.特殊設計的氨氣回收裝置。
5. 采用大屏幕真彩控制器,簡潔明了的氨氣試驗專用界面,簡單的編程設定,充分的數據儲存手段:SD卡、S485、232等標准接口。

 

基本技術參數

容積和尺寸 Capacity and dimension

標稱內容積

Nominal interior capacity(milemeter)

7.92

標稱內箱尺寸

Interior dimension (mm)

W1500XH2200XD2400

門孔尺寸

Door hole size(mm)

單開Single type W1200XH2200
性能 Performance

溫度範圍

Temperature range

20℃~+85℃

溫度波動度

Temperature fluctuation

±0.5℃
溫度波動度(空載條件下,設備在穩定狀態下,工作空間中心點溫度隨時間的變化量,實測最高溫度與最低溫度之的一半,以+-表示,即溫度波動度
Temperature fluctuation (when the equipment is in stable and unladen condition, the variation value of middle point temperature of working space with the time, half of the actual max. temperature and min. temperature, it is called the temperature fluctuation)

溫度偏差

Temperature deviation

±2℃
空載條件下,設備中心點在規定時間內測量的平均值與設備顯示溫度平均值之差,即溫度偏差Temperature deviation (when unladed, the difference of the average value tested by the middle point of equipment within set time and the average value of temperature displayed by the equipment. It is called temperature deviation
溫度均勻度    Temperature uniformity ≦2℃
空載條件下,設備達到穩定後,每次測試中實測最高溫度與最低溫度之差的算術平均值,即溫度均勻度                                                   When the equipment is stable and unladed, the arithmetic average of the difference between max. temperature and min. temperature of each test. It is called temperature uniformity
濕度範圍Humidity range 25~100%RH(+20℃~+85℃)如圖1所示 refer to Chart 1

相對濕度偏差

Relative humidity deviation

+2,-3%RH(>75%RH)
空載條件下,設備中心點在規定時間內測量的平均值與設備顯示溫度平均值之差,即溫度偏差when unladed, the difference of the average value tested by the middle point of equipment within set time and the average value of temperature displayed by the equipment. It is called relative humidity deviation

氨濃度

Ammonia concentration

0~10000ppm可調(adjustable)

測試標准 

Test standard

GB/T5170.2-2008

指定試驗曲線

Specify test curve 

滿足標准IEC62716氨檢測試驗要求(如圖2所示) can meet Ammonia test standard IEC62716 (refer to Chart 2)
Products